Name:
4-Chlorostyrene stabilized with 0.1% tert-butylcatechol
Synonym:
p-Chlorostyrene; 1-Chloro-4-ethenylbenzene
Section 1 - Chemical Product
MSDS Name:4-Chlorostyrene stabilized with 0.1% tert-butylcatechol
Synonym:p-Chlorostyrene; 1-Chloro-4-ethenylbenzene
Section 2 - COMPOSITION, INFORMATION ON INGREDIENTS
| CAS# | Chemical Name | emsds | EINECS# |
| 98-29-3 | 4-tert-Butylcatechol | 0.1 | 202-653-9 |
Hazard Symbols: XI Risk Phrases: 36/37/38 |
Section 3 - HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW
Irritating to eyes, respiratory system and skin.
Potential Health Effects
Eye:
Causes eye irritation.
Skin:
Causes skin irritation. May be harmful if absorbed through the skin.
Ingestion:
May cause gastrointestinal irritation with nausea, vomiting and diarrhea. May be harmful if swallowed.
Inhalation:
Causes respiratory tract irritation. May be harmful if inhaled.
Chronic:
No information found.
Section 4 - FIRST AID MEASURES
Eyes: In case of contact, immediately flush eyes with plenty of water for at least 15 minutes. Get medical aid.
Skin:
In case of contact, flush skin with plenty of water. Remove contaminated clothing and shoes. Get medical aid if irritation develops and persists. Wash clothing before reuse.
Ingestion:
If swallowed, do not induce vomiting unless directed to do so by medical personnel. Never give anything by mouth to an unconscious person. Get medical aid.
Inhalation:
If inhaled, remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get medical aid.
Notes to Physician:
Section 5 - FIRE FIGHTING MEASURES
General Information:
As in any fire, wear a self-contained breathing apparatus in pressure-demand, MSHA/NIOSH (approved or equivalent), and full protective gear. Vapors may form an explosive mixture with air.
During a fire, irritating and highly toxic gases may be generated by thermal decomposition or combustion. Use water spray to keep fire-exposed containers cool. Containers may explode in the heat of a fire. Flammable liquid and vapor. Vapors are heavier than air and may travel to a source of ignition and flash back. Vapors can spread along the ground and collect in low or confined areas. Hazardous polymerization may occur under fire conditions.
Extinguishing Media:
Use water spray, dry chemical, carbon dioxide, or chemical foam.
Section 6 - ACCIDENTAL RELEASE MEASURES
General Information: Use proper personal protective equipment as indicated in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth), then place in suitable container. Clean up spills immediately, observing precautions in the Protective Equipment section. Remove all sources of ignition. Use a spark-proof tool. Provide ventilation. A vapor suppressing foam may be used to reduce vapors.
Section 7 - HANDLING and STORAGE
Handling:
Wash thoroughly after handling. Remove contaminated clothing and wash before reuse. Use with adequate ventilation. Ground and bond containers when transferring material. Use spark-proof tools and explosion proof equipment. Avoid contact with eyes, skin, and clothing. Empty containers retain product residue, (liquid and/or vapor), and can be dangerous. Keep container tightly closed. Do not pressurize, cut, weld, braze, solder, drill, grind, or expose empty containers to heat, sparks or open flames. Keep away from heat, sparks and flame. Avoid breathing vapor or mist. Pure vapor will be uninhibited and may polymerize in vents or other confined spaces.
Storage:
Keep away from sources of ignition. Keep container closed when not in use. Store in a cool, dry, well-ventilated area away from incompatible substances. Flammables-area. Keep refrigerated. (Store below 4C/39F.)
Section 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION
Engineering Controls:
Facilities storing or utilizing this material should be equipped with an eyewash facility and a safety shower. Use adequate ventilation to keep airborne concentrations low.
Exposure Limits CAS# 98-29-3: CAS# 1073-67-2: Personal Protective Equipment Eyes: Wear chemical splash goggles.
Skin:
Wear appropriate protective gloves to prevent skin exposure.
Clothing:
Wear appropriate protective clothing to prevent skin exposure.
Respirators:
Follow the OSHA respirator regulations found in 29 CFR 1910.134 or European Standard EN 149. Use a NIOSH/MSHA or European Standard EN 149 approved respirator if exposure limits are exceeded or if irritation or other symptoms are experienced.
Section 9 - PHYSICAL AND CHEMICAL PROPERTIES
Physical State: Liquid
Color: clear colorless to slightly yellow
Odor: characteristic odor
pH: Not available.
Vapor Pressure: 0.816 mm Hg @ 25 deg C
Viscosity: Not available.
Boiling Point: 192 deg C @ 760 mm Hg
Freezing/Melting Point: -16 deg C
Autoignition Temperature: Not available.
Flash Point: 60 deg C ( 140.00 deg F)
Explosion Limits, lower: N/A
Explosion Limits, upper: N/A
Decomposition Temperature:
Solubility in water: Insoluble.
Specific Gravity/Density: 1.1000 g/cm3
Molecular Formula: C8H7Cl
Molecular Weight: 138.60
Section 10 - STABILITY AND REACTIVITY
Chemical Stability:
Stable. However, it may undergo explosive polymerization if uninhibited.
Conditions to Avoid:
Light, ignition sources, excess heat.
Incompatibilities with Other Materials:
Strong oxidizing agents, acids, metal salts, polymerizing initiators.
Hazardous Decomposition Products:
Hydrogen chloride, carbon monoxide, carbon dioxide.
Hazardous Polymerization: May occur.
Section 11 - TOXICOLOGICAL INFORMATION
RTECS#:
CAS# 98-29-3: UX1400000 CAS# 1073-67-2: CZ0533000 LD50/LC50:
CAS# 98-29-3: Draize test, rabbit, skin: 750 ug/24H Severe; Oral, rat: LD50 = 2820 mg/kg; Skin, rabbit: LD50 = 630 uL/kg.
CAS# 1073-67-2.
Carcinogenicity:
4-tert-Butylcatechol - Not listed by ACGIH, IARC, or NTP.
4-Chlorostyrene - Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.
Section 12 - ECOLOGICAL INFORMATION
Other No information available.
Section 13 - DISPOSAL CONSIDERATIONS
Dispose of in a manner consistent with federal, state, and local regulations.
Section 14 - TRANSPORT INFORMATION
IATA
Shipping Name: FLAMMABLE LIQUID, N.O.S.
Hazard Class: 3
UN Number: 1993
Packing Group: III
IMO
Shipping Name: FLAMMABLE LIQUID, N.O.S.
Hazard Class: 3
UN Number: 1993
Packing Group: III
RID/ADR
Shipping Name: FLAMMABLE LIQUID, N.O.S.
Hazard Class: 3
UN Number: 1993
Packing group: III
Section 15 - REGULATORY INFORMATION
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 36/37/38 Irritating to eyes, respiratory system
and skin.
Safety Phrases:
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
S 37/39 Wear suitable gloves and eye/face
protection.
WGK (Water Danger/Protection)
CAS# 98-29-3: No information available.
CAS# 1073-67-2: No information available.
Canada
CAS# 98-29-3 is listed on Canadas DSL List.
CAS# 1073-67-2 is listed on Canadas NDSL List.
CAS# 98-29-3 is listed on Canadas Ingredient Disclosure List.
CAS# 1073-67-2 is not listed on Canadas Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 98-29-3 is listed on the TSCA inventory.
CAS# 1073-67-2 is listed on the TSCA inventory.