Name:
Copper(II) trifluoromethanesulfonate
Synonym:
CAS:
34946-82-2
Section 1 - Chemical Product
MSDS Name:Copper(II) trifluoromethanesulfonate
Synonym:
Synonym:
Section 2 - COMPOSITION, INFORMATION ON INGREDIENTS
| CAS# | Chemical Name | emsds | EINECS# |
| 34946-82-2 | Copper (II) trifluoromethanesulfonate | >99 | 252-300-8 |
| Hazard Symbols: C Risk Phrases: 34 |
Section 3 - HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW
Causes burns.Moisture sensitive.The toxicological properties of this material have not been fully investigated.Corrosive.
Potential Health Effects
Eye:
Causes eye burns.
Skin:
Causes skin burns.
Ingestion:
May cause severe and permanent damage to the digestive tract. Causes gastrointestinal tract burns.
Inhalation:
Causes chemical burns to the respiratory tract.
Chronic:
No information found.
Causes burns.Moisture sensitive.The toxicological properties of this material have not been fully investigated.Corrosive.
Potential Health Effects
Eye:
Causes eye burns.
Skin:
Causes skin burns.
Ingestion:
May cause severe and permanent damage to the digestive tract. Causes gastrointestinal tract burns.
Inhalation:
Causes chemical burns to the respiratory tract.
Chronic:
No information found.
Section 4 - FIRST AID MEASURES
Eyes: Flush eyes with plenty of water for at least 15 minutes, occasionally lifting the upper and lower eyelids. Get medical aid immediately. Do NOT allow victim to rub eyes or keep eyes closed.
Extensive irrigation with water is required (at least 30 minutes).
Skin:
Get medical aid immediately. Immediately flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes. Wash clothing before reuse. Destroy contaminated shoes.
Ingestion:
Do not induce vomiting. If victim is conscious and alert, give 2-4 cupfuls of milk or water. Never give anything by mouth to an unconscious person. Get medical aid immediately.
Inhalation:
Get medical aid immediately. Remove from exposure and move to fresh air immediately. If breathing is difficult, give oxygen. Do NOT use mouth-to-mouth resuscitation. If breathing has ceased apply artificial respiration using oxygen and a suitable mechanical device such as a bag and a mask.
Notes to Physician:
Extensive irrigation with water is required (at least 30 minutes).
Skin:
Get medical aid immediately. Immediately flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes. Wash clothing before reuse. Destroy contaminated shoes.
Ingestion:
Do not induce vomiting. If victim is conscious and alert, give 2-4 cupfuls of milk or water. Never give anything by mouth to an unconscious person. Get medical aid immediately.
Inhalation:
Get medical aid immediately. Remove from exposure and move to fresh air immediately. If breathing is difficult, give oxygen. Do NOT use mouth-to-mouth resuscitation. If breathing has ceased apply artificial respiration using oxygen and a suitable mechanical device such as a bag and a mask.
Notes to Physician:
Section 5 - FIRE FIGHTING MEASURES
General Information:
As in any fire, wear a self-contained breathing apparatus in pressure-demand, MSHA/NIOSH (approved or equivalent), and full protective gear. During a fire, irritating and highly toxic gases may be generated by thermal decomposition or combustion.
Extinguishing Media:
Use water spray, dry chemical, carbon dioxide, or appropriate foam.
As in any fire, wear a self-contained breathing apparatus in pressure-demand, MSHA/NIOSH (approved or equivalent), and full protective gear. During a fire, irritating and highly toxic gases may be generated by thermal decomposition or combustion.
Extinguishing Media:
Use water spray, dry chemical, carbon dioxide, or appropriate foam.
Section 6 - ACCIDENTAL RELEASE MEASURES
General Information: Use proper personal protective equipment as indicated in Section 8.
Spills/Leaks:
Clean up spills immediately, observing precautions in the Protective Equipment section. Sweep up or absorb material, then place into a suitable clean, dry, closed container for disposal. Avoid generating dusty conditions. Provide ventilation.
Spills/Leaks:
Clean up spills immediately, observing precautions in the Protective Equipment section. Sweep up or absorb material, then place into a suitable clean, dry, closed container for disposal. Avoid generating dusty conditions. Provide ventilation.
Section 7 - HANDLING and STORAGE
Handling:
Wash thoroughly after handling. Remove contaminated clothing and wash before reuse. Use only in a well-ventilated area. Minimize dust generation and accumulation. Keep container tightly closed. Do not get on skin or in eyes. Do not ingest or inhale. Discard contaminated shoes.
Storage:
Keep container closed when not in use. Store in a tightly closed container. Store in a cool, dry, well-ventilated area away from incompatible substances.
Wash thoroughly after handling. Remove contaminated clothing and wash before reuse. Use only in a well-ventilated area. Minimize dust generation and accumulation. Keep container tightly closed. Do not get on skin or in eyes. Do not ingest or inhale. Discard contaminated shoes.
Storage:
Keep container closed when not in use. Store in a tightly closed container. Store in a cool, dry, well-ventilated area away from incompatible substances.
Section 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION
Engineering Controls:
Use adequate ventilation to keep airborne concentrations low.
Exposure Limits CAS# 34946-82-2: United Kingdom, WEL - TWA: (listed as copper): 0.2 mg/m3 TWA (fum 1 mg/m3 TWA (dust and mist) United Kingdom, WEL - STEL: (listed as copper): 0.6 mg/m3 STEL (fume); 2 mg/m3 STEL (dust and mist) United States OSHA: 0.1 mg/m3 TWA (fume); 1 mg/m3 TWA (dusts and mists) (listed under Copper).
Belgium - TWA: (listed as copper): 0.2 mg/m3 VLE (fume); 1 mg/m3 (dust and mist) France - VME: (listed as copper): 0.2 mg/m3 VME (fume); 1 mg/m3 V (dust, as Cu) France - VLE: (listed as copper): 2 mg/m3 VLE (dust, as Cu) Germany: (listed as copper): 0.2 mg/m3 VME (fume); 1 mg/m3 VME (d as Cu) Malaysia: (listed as copper): 0.2 mg/m3 TWA (fume, as Cu); 1 mg/m TWA (dust and mist, as Cu) Netherlands: (listed as copper): 0.2 mg/m3 MAC (smoke); 1 mg/m3 M (dust) Russia: (listed as copper): 1 mg/m3 TWA (dust) Russia: (listed as copper): 0.5 mg/m3 STEL (dust) Spain: (listed as copper): 0.2 mg/m3 VLA-ED (fume); 1 mg/m3 VLA-E (dust and mist, as Cu) Personal Protective Equipment Eyes: Wear appropriate protective eyeglasses or chemical safety goggles as described by OSHAs eye and face protection regulations in 29 CFR 1910.133 or European Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin exposure.
Clothing:
Wear appropriate protective clothing to prevent skin exposure.
Respirators:
Follow the OSHA respirator regulations found in 29 CFR 1910.134 or European Standard EN 149. Use a NIOSH/MSHA or European Standard EN 149 approved respirator if exposure limits are exceeded or if irritation or other symptoms are experienced.
Use adequate ventilation to keep airborne concentrations low.
Exposure Limits CAS# 34946-82-2: United Kingdom, WEL - TWA: (listed as copper): 0.2 mg/m3 TWA (fum 1 mg/m3 TWA (dust and mist) United Kingdom, WEL - STEL: (listed as copper): 0.6 mg/m3 STEL (fume); 2 mg/m3 STEL (dust and mist) United States OSHA: 0.1 mg/m3 TWA (fume); 1 mg/m3 TWA (dusts and mists) (listed under Copper).
Belgium - TWA: (listed as copper): 0.2 mg/m3 VLE (fume); 1 mg/m3 (dust and mist) France - VME: (listed as copper): 0.2 mg/m3 VME (fume); 1 mg/m3 V (dust, as Cu) France - VLE: (listed as copper): 2 mg/m3 VLE (dust, as Cu) Germany: (listed as copper): 0.2 mg/m3 VME (fume); 1 mg/m3 VME (d as Cu) Malaysia: (listed as copper): 0.2 mg/m3 TWA (fume, as Cu); 1 mg/m TWA (dust and mist, as Cu) Netherlands: (listed as copper): 0.2 mg/m3 MAC (smoke); 1 mg/m3 M (dust) Russia: (listed as copper): 1 mg/m3 TWA (dust) Russia: (listed as copper): 0.5 mg/m3 STEL (dust) Spain: (listed as copper): 0.2 mg/m3 VLA-ED (fume); 1 mg/m3 VLA-E (dust and mist, as Cu) Personal Protective Equipment Eyes: Wear appropriate protective eyeglasses or chemical safety goggles as described by OSHAs eye and face protection regulations in 29 CFR 1910.133 or European Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin exposure.
Clothing:
Wear appropriate protective clothing to prevent skin exposure.
Respirators:
Follow the OSHA respirator regulations found in 29 CFR 1910.134 or European Standard EN 149. Use a NIOSH/MSHA or European Standard EN 149 approved respirator if exposure limits are exceeded or if irritation or other symptoms are experienced.
Section 9 - PHYSICAL AND CHEMICAL PROPERTIES
Physical State: Solid
Color: Not available.
Odor: Not available.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: Not available.
Freezing/Melting Point: 0 deg C
Autoignition Temperature: Not available.
Flash Point: Not available.
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water:
Specific Gravity/Density:
Molecular Formula: C2F6S2O6Cu
Molecular Weight: 361.69
Section 10 - STABILITY AND REACTIVITY
Chemical Stability:
Stable under normal temperatures and pressures. May decompose on exposure to moist air or water.
Conditions to Avoid:
Incompatible materials, dust generation, moisture, strong oxidants.
Incompatibilities with Other Materials:
Strong oxidizing agents.
Hazardous Decomposition Products:
Carbon monoxide, oxides of sulfur, carbon dioxide, hydrogen fluoride gas.
Hazardous Polymerization: Has not been reported
Stable under normal temperatures and pressures. May decompose on exposure to moist air or water.
Conditions to Avoid:
Incompatible materials, dust generation, moisture, strong oxidants.
Incompatibilities with Other Materials:
Strong oxidizing agents.
Hazardous Decomposition Products:
Carbon monoxide, oxides of sulfur, carbon dioxide, hydrogen fluoride gas.
Hazardous Polymerization: Has not been reported
Section 11 - TOXICOLOGICAL INFORMATION
RTECS#:
CAS# 34946-82-2 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
Copper (II) trifluoromethanesulfonate - Not listed by ACGIH, IARC, or NTP.
CAS# 34946-82-2 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
Copper (II) trifluoromethanesulfonate - Not listed by ACGIH, IARC, or NTP.
Section 12 - ECOLOGICAL INFORMATION
Section 13 - DISPOSAL CONSIDERATIONS
Dispose of in a manner consistent with federal, state, and local regulations.
Section 14 - TRANSPORT INFORMATION
IATA
Shipping Name: CORROSIVE SOLID, N.O.S.*
Hazard Class: 8
UN Number: 1759
Packing Group: II
IMO
Shipping Name: CORROSIVE SOLID, N.O.S.
Hazard Class: 8
UN Number: 1759
Packing Group: II
RID/ADR
Shipping Name: CORROSIVE SOLID, N.O.S.
Hazard Class: 8
UN Number: 1759
Packing group: II
Section 15 - REGULATORY INFORMATION
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: C
Risk Phrases:
R 34 Causes burns.
Safety Phrases:
S 25 Avoid contact with eyes.
S 28A After contact with skin, wash immediately with
plenty of water.
S 36/37/39 Wear suitable protective clothing, gloves
and eye/face protection.
S 37 Wear suitable gloves.
S 45 In case of accident or if you feel unwell, seek
medical advice immediately (show the label where
possible).
WGK (Water Danger/Protection)
CAS# 34946-82-2: No information available.
Canada
None of the chemicals in this product are listed on the DSL/NDSL list.
CAS# 34946-82-2 is not listed on Canadas Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 34946-82-2 is not listed on the TSCA inventory.
It is for research and development use only.
