Name:
Diethylphosphoramidous Dichloride 97%
Section 1 - Chemical Product
MSDS Name:Diethylphosphoramidous Dichloride 97%
Synonym:
Section 2 - COMPOSITION, INFORMATION ON INGREDIENTS
| CAS# | Chemical Name | emsds | EINECS# |
| 1069-08-5 | Diethylphosphoramidous dichloride | 97% | unlisted |
Hazard Symbols: C Risk Phrases: 14 34 5 |
Section 3 - HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW
Reacts violently with water. Causes burns. Heating may cause an explosion.Corrosive.
Potential Health Effects
Eye:
Causes eye burns.
Skin:
Causes skin burns.
Ingestion:
May cause severe and permanent damage to the digestive tract. Causes gastrointestinal tract burns.
Inhalation:
May cause irritation of the respiratory tract with burning pain in the nose and throat, coughing, wheezing, shortness of breath and pulmonary edema. Causes chemical burns to the respiratory tract.
Inhalation may be fatal as a result of spasm, inflammation, edema of the larynx and bronchi, chemical pneumonitis and pulmonary edema.
Chronic:
No information found.
Section 4 - FIRST AID MEASURES
Eyes: Get medical aid immediately. Do NOT allow victim to rub eyes or keep eyes closed. Extensive irrigation with water is required (at least 30 minutes).
Skin:
Get medical aid immediately. Immediately flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes. Wash clothing before reuse. Destroy contaminated shoes.
Ingestion:
Do not induce vomiting. If victim is conscious and alert, give 2-4 cupfuls of milk or water. Never give anything by mouth to an unconscious person. Get medical aid immediately.
Inhalation:
Get medical aid immediately. Remove from exposure and move to fresh air immediately. If breathing is difficult, give oxygen. Do NOT use mouth-to-mouth resuscitation. If breathing has ceased apply artificial respiration using oxygen and a suitable mechanical device such as a bag and a mask.
Notes to Physician:
Section 5 - FIRE FIGHTING MEASURES
General Information:
As in any fire, wear a self-contained breathing apparatus in pressure-demand, MSHA/NIOSH (approved or equivalent), and full protective gear. Exposure to heat may promote violent decomposition.
During a fire, irritating and highly toxic gases may be generated by thermal decomposition or combustion. Will burn if involved in a fire. Water Reactive. Material will react with water and may release a flammable and/or toxic gas. Use water spray to keep fire-exposed containers cool. Combustible liquid. Vapors may be heavier than air.
They can spread along the ground and collect in low or confined areas. May ignite or explode on contact with steam or moist air.
Containers may explode when heated.
Extinguishing Media:
Use dry sand or earth to smother fire. Use water spray to cool fire-exposed containers. Use foam, dry chemical, or carbon dioxide.
DO NOT USE WATER! Contact professional fire-fighters immediately.
Section 6 - ACCIDENTAL RELEASE MEASURES
General Information: Use proper personal protective equipment as indicated in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth), then place in suitable container. Avoid runoff into storm sewers and ditches which lead to waterways. Clean up spills immediately, observing precautions in the Protective Equipment section. Remove all sources of ignition. Provide ventilation. Do not expose spill to water.
Section 7 - HANDLING and STORAGE
Handling:
Wash thoroughly after handling. Use only in a well-ventilated area.
Do not allow water to get into the container because of violent reaction. Do not breathe dust, vapor, mist, or gas. Do not get in eyes, on skin, or on clothing. Empty containers retain product residue, (liquid and/or vapor), and can be dangerous. Keep away from heat, sparks and flame. Do not ingest or inhale. Do not allow contact with water. Use only in a chemical fume hood. Store and handle protected from air. Do not pressurize, cut, weld, braze, solder, drill, grind, or expose empty containers to heat, sparks or open flames. Keep from contact with moist air and steam.
Storage:
Keep away from heat, sparks, and flame. Keep away from sources of ignition. Keep container closed when not in use. Keep under a nitrogen blanket. Store in a cool, dry, well-ventilated area away from incompatible substances. Keep away from water. Corrosives area.
Keep refrigerated. (Store below 4C/39F.)
Section 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION
Engineering Controls:
Use explosion-proof ventilation equipment. Facilities storing or utilizing this material should be equipped with an eyewash facility and a safety shower. Use adequate ventilation to keep airborne concentrations low.
Exposure Limits CAS# 1069-08-5: Personal Protective Equipment Eyes: Wear appropriate protective eyeglasses or chemical safety goggles as described by OSHAs eye and face protection regulations in 29 CFR 1910.133 or European Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin exposure.
Clothing:
Wear appropriate protective clothing to minimize contact with skin.
Respirators:
A respiratory protection program that meets OSHAs 29 CFR 1910.134 and ANSI Z88.2 requirements or European Standard EN 149 must be followed whenever workplace conditions warrant respirator use.
Section 9 - PHYSICAL AND CHEMICAL PROPERTIES
Physical State: Liquid
Color: pale-yellow
Odor: Not available.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: 179 deg C
Freezing/Melting Point: Not available.
Autoignition Temperature: Not available.
Flash Point: 82 deg C ( 179.60 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water:
Specific Gravity/Density: 1.1960g/cm3
Molecular Formula: C4H10Cl2NP
Molecular Weight: 174.01
Section 10 - STABILITY AND REACTIVITY
Chemical Stability:
Combines vigorously or explosively with water.
Conditions to Avoid:
High temperatures, incompatible materials, ignition sources, contact with water, excess heat, exposure to moist air or water.
Incompatibilities with Other Materials:
Acids, alcohols, amines, strong bases, strong oxidizing agents, strong reducing agents.
Hazardous Decomposition Products:
Hydrogen chloride, nitrogen oxides, phosphine, carbon monoxide, oxides of phosphorus, carbon dioxide.
Hazardous Polymerization: Has not been reported
Section 11 - TOXICOLOGICAL INFORMATION
RTECS#:
CAS# 1069-08-5 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
Diethylphosphoramidous dichloride - Not listed by ACGIH, IARC, or NTP.
Section 12 - ECOLOGICAL INFORMATION
Section 13 - DISPOSAL CONSIDERATIONS
Dispose of in a manner consistent with federal, state, and local regulations.
Section 14 - TRANSPORT INFORMATION
IATA
Shipping Name: CORROSIVE LIQUID, N.O.S.*
Hazard Class: 8
UN Number: 1760
Packing Group: II
IMO
Shipping Name: CORROSIVE LIQUID, N.O.S.
Hazard Class: 8
UN Number: 1760
Packing Group: II
RID/ADR
Shipping Name: CORROSIVE LIQUID, N.O.S.
Hazard Class: 8
UN Number: 1760
Packing group: II
Section 15 - REGULATORY INFORMATION
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: C
Risk Phrases:
R 14 Reacts violently with water.
R 34 Causes burns.
R 5 Heating may cause an explosion.
Safety Phrases:
S 3/9/49 Keep only in the original container in a
cool, well-ventilated place.
S 36/39 Wear suitable protective clothing and
eye/face protection.
WGK (Water Danger/Protection)
CAS# 1069-08-5: No information available.
Canada
None of the chemicals in this product are listed on the DSL/NDSL list.
CAS# 1069-08-5 is not listed on Canadas Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 1069-08-5 is not listed on the TSCA inventory.
It is for research and development use only.