英文MSDS库
当前位置:化工字典 > 英文MSDS
Name:
p-Toluene Sulfonic Acid Monohydrate Cr 500g
Synonym:
Benzenesulfonic acid, 4-methyl-, monohydrate; Toluene, 4-sulfonic acid, monohydrat
CAS:
6192-52-5
Section 1 - Chemical Product
MSDS Name:p-Toluene Sulfonic Acid Monohydrate Cr 500g
Synonym:Benzenesulfonic acid, 4-methyl-, monohydrate; Toluene, 4-sulfonic acid, monohydrat
Section 2 - COMPOSITION, INFORMATION ON INGREDIENTS
CAS# Chemical Name emsds EINECS#
6192-52-5 p-Toluenesulfonic acid monohydrate 99 unlisted
Hazard Symbols: XI
Risk Phrases: 36/37/38

Section 3 - HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW
Irritating to eyes, respiratory system and skin.Hygroscopic (absorbs moisture from the air).The toxicological properties of this material have not been fully investigated.
Potential Health Effects
Eye:
May cause irreversible eye injury. Causes eye irritation and possible burns.
Skin:
Causes skin irritation and possible burns.
Ingestion:
Causes digestive tract irritation with possible burns.
Inhalation:
May cause severe irritation of the respiratory tract with sore throat, coughing, shortness of breath and delayed lung edema. May cause burns to the respiratory tract.
Chronic:
No information found.

Section 4 - FIRST AID MEASURES
Eyes: Immediately flush eyes with plenty of water for at least 15 minutes, occasionally lifting the upper and lower eyelids. Get medical aid immediately.
Skin:
Get medical aid immediately. Immediately flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes. Destroy contaminated shoes.
Ingestion:
Do not induce vomiting. If victim is conscious and alert, give 2-4 cupfuls of milk or water. Never give anything by mouth to an unconscious person. Get medical aid immediately.
Inhalation:
Get medical aid immediately. Remove from exposure and move to fresh air immediately. If breathing is difficult, give oxygen. Do NOT use mouth-to-mouth resuscitation. If breathing has ceased apply artificial respiration using oxygen and a suitable mechanical device such as a bag and a mask.
Notes to Physician:

Section 5 - FIRE FIGHTING MEASURES
General Information:
Wear appropriate protective clothing to prevent contact with skin and eyes. Wear a self-contained breathing apparatus (SCBA) to prevent contact with thermal decomposition products. Containers may explode in the heat of a fire. Vapors may be heavier than air. They can spread along the ground and collect in low or confined areas.
Extinguishing Media:
In case of fire, use water, dry chemical, chemical foam, or alcohol-resistant foam. Use extinguishing media most appropriate for the surrounding fire. Cool containers with flooding quantities of water until well after fire is out.

Section 6 - ACCIDENTAL RELEASE MEASURES
General Information: Use proper personal protective equipment as indicated in Section 8.
Spills/Leaks:
Vacuum or sweep up material and place into a suitable disposal container. Clean up spills immediately, observing precautions in the Protective Equipment section. Avoid generating dusty conditions.
Provide ventilation.

Section 7 - HANDLING and STORAGE
Handling:
Wash thoroughly after handling. Remove contaminated clothing and wash before reuse. Minimize dust generation and accumulation. Do not get in eyes, on skin, or on clothing. Keep container tightly closed.
Do not ingest or inhale. Use only in a chemical fume hood. Discard contaminated shoes.
Storage:
Keep container closed when not in use. Store in a cool, dry, well-ventilated area away from incompatible substances. Do not store near alkaline substances. Store protected from moisture.

Section 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION
Engineering Controls:
Facilities storing or utilizing this material should be equipped with an eyewash facility and a safety shower. Use adequate ventilation to keep airborne concentrations low.
Personal Protective Equipment Eyes: Wear appropriate protective eyeglasses or chemical safety goggles as described by OSHAs eye and face protection regulations in 29 CFR 1910.133 or European Standard EN166.
Skin:
Wear appropriate gloves to prevent skin exposure.
Clothing:
Wear appropriate protective clothing to prevent skin exposure.
Respirators:
A respiratory protection program that meets OSHAs 29 CFR 1910.134 and ANSI Z88.2 requirements or European Standard EN 149 must be followed whenever workplace conditions warrant a respirators use.

Section 9 - PHYSICAL AND CHEMICAL PROPERTIES

Physical State: Crystals
Color: white
Odor: none reported
pH: Not applicable.
Vapor Pressure: Not applicable.
Viscosity: Not available.
Boiling Point: 140 deg C @ 27 mmHg
Freezing/Melting Point: 103 deg C
Autoignition Temperature: Not applicable.
Flash Point: 103 deg C ( 217.40 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature: Not available.
Solubility in water: Soluble.
Specific Gravity/Density: Not available.
Molecular Formula: C7H8O3S.H2O
Molecular Weight: 172.1142

Section 10 - STABILITY AND REACTIVITY
Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, dust generation, moisture, excess heat, exposure to moist air or water.
Incompatibilities with Other Materials:
Moisture.
Hazardous Decomposition Products:
Carbon monoxide, oxides of sulfur, irritating and toxic fumes and gases, carbon dioxide, sodium oxide.
Hazardous Polymerization: Has not been reported.

Section 11 - TOXICOLOGICAL INFORMATION
RTECS#:
CAS# 6192-52-5: DB7164000 LD50/LC50:
CAS# 6192-52-5: Oral, mouse: LD50 = 1683 mg/kg; Oral, rat: LD50 = 2570 mg/kg.
Carcinogenicity:
p-Toluenesulfonic acid monohydrate - Not listed by ACGIH, IARC, or NTP.
See actual entry in RTECS for complete information.

Section 12 - ECOLOGICAL INFORMATION

Section 13 - DISPOSAL CONSIDERATIONS
Products which are considered hazardous for supply are classified as Special Waste and the disposal of such chemicals is covered by regulations which may vary according to location. Contact a specialist disposal company or the local waste regulator for advice. Empty containers must be decontaminated before returning for recycling.

Section 14 - TRANSPORT INFORMATION

IATA
Shipping Name: CORROSIVE SOLID, NOS
Hazard Class: 8
UN Number: 1759
Packing Group: II
IMO
Shipping Name: CORROSIVE SOLID, NOS
Hazard Class: 8
UN Number: 1759
Packing Group: II
RID/ADR
Shipping Name: CORROSIVE SOLID, NOS
Hazard Class: 8
UN Number: 1759
Packing group: II

Section 15 - REGULATORY INFORMATION

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 36/37/38 Irritating to eyes, respiratory system
and skin.
Safety Phrases:
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
S 37 Wear suitable gloves.
WGK (Water Danger/Protection)
CAS# 6192-52-5: 1
United Kingdom Occupational Exposure Limits

United Kingdom Maximum Exposure Limits

Canada
None of the chemicals in this product are listed on the DSL/NDSL list.
CAS# 6192-52-5 is not listed on Canadas Ingredient Disclosure List.
Exposure Limits
US FEDERAL
TSCA
CAS# 6192-52-5 is not on the TSCA Inventory because it is a hydrate.
It is considered to be listed if the CAS number for the anhydrous form
is on the inventory (40CFR720.3(u)(2)).