Name:
Palladium on 4- to 8-mesh carbon (1% Pd)
Synonym:
None
CAS:
Section 1 - Chemical Product
MSDS Name:Palladium on 4- to 8-mesh carbon (1% Pd)
Synonym:None
Synonym:None
Section 2 - COMPOSITION, INFORMATION ON INGREDIENTS
| CAS# | Chemical Name | emsds | EINECS# |
| Palladium | 1% | 231-115-6 |
| Hazard Symbols: F Risk Phrases: 7 |
Section 3 - HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW
May cause fire.
Potential Health Effects
Eye:
May cause eye irritation.
Skin:
May cause skin irritation.
Ingestion:
May cause irritation of the digestive tract.
Inhalation:
May cause respiratory tract irritation.
Chronic:
None
May cause fire.
Potential Health Effects
Eye:
May cause eye irritation.
Skin:
May cause skin irritation.
Ingestion:
May cause irritation of the digestive tract.
Inhalation:
May cause respiratory tract irritation.
Chronic:
None
Section 4 - FIRST AID MEASURES
Eyes: Flush eyes with plenty of water for at least 15 minutes, occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes. Get medical aid if irritation develops or persists. Wash clothing before reuse.
Ingestion:
If victim is conscious and alert, give 2-4 cupfuls of milk or water.
Never give anything by mouth to an unconscious person. Get medical aid.
Inhalation:
Remove from exposure and move to fresh air immediately. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get medical aid if cough or other symptoms appear.
Notes to Physician:
Skin:
Flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes. Get medical aid if irritation develops or persists. Wash clothing before reuse.
Ingestion:
If victim is conscious and alert, give 2-4 cupfuls of milk or water.
Never give anything by mouth to an unconscious person. Get medical aid.
Inhalation:
Remove from exposure and move to fresh air immediately. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get medical aid if cough or other symptoms appear.
Notes to Physician:
Section 5 - FIRE FIGHTING MEASURES
General Information:
As in any fire, wear a self-contained breathing apparatus in pressure-demand, MSHA/NIOSH (approved or equivalent), and full protective gear. Will burn if involved in a fire.
Extinguishing Media:
Use water spray, dry chemical, or carbon dioxide. Use agent most appropriate to extinguish fire.
As in any fire, wear a self-contained breathing apparatus in pressure-demand, MSHA/NIOSH (approved or equivalent), and full protective gear. Will burn if involved in a fire.
Extinguishing Media:
Use water spray, dry chemical, or carbon dioxide. Use agent most appropriate to extinguish fire.
Section 6 - ACCIDENTAL RELEASE MEASURES
General Information: Use proper personal protective equipment as indicated in Section 8.
Spills/Leaks:
Vacuum or sweep up material and place into a suitable disposal container. Remove all sources of ignition. Use a spark-proof tool.
Spills/Leaks:
Vacuum or sweep up material and place into a suitable disposal container. Remove all sources of ignition. Use a spark-proof tool.
Section 7 - HANDLING and STORAGE
Handling:
Use spark-proof tools and explosion proof equipment. Avoid breathing dust, vapor, mist, or gas. Avoid contact with skin and eyes. Empty containers retain product residue, (liquid and/or vapor), and can be dangerous. Use only in a chemical fume hood. Do not pressurize, cut, weld, braze, solder, drill, grind, or expose empty containers to heat, sparks or open flames.
Storage:
Keep away from sources of ignition. Store in a cool, dry place.
Store in a tightly closed container. Flammables-area.
Use spark-proof tools and explosion proof equipment. Avoid breathing dust, vapor, mist, or gas. Avoid contact with skin and eyes. Empty containers retain product residue, (liquid and/or vapor), and can be dangerous. Use only in a chemical fume hood. Do not pressurize, cut, weld, braze, solder, drill, grind, or expose empty containers to heat, sparks or open flames.
Storage:
Keep away from sources of ignition. Store in a cool, dry place.
Store in a tightly closed container. Flammables-area.
Section 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION
Engineering Controls:
Facilities storing or utilizing this material should be equipped with an eyewash facility and a safety shower. Use adequate general or local explosion-proof ventilation to keep airborne levels to acceptable levels.
Exposure Limits CAS# : United Kingdom, WEL - TWA: (listed as tellurium): 0.1 mg/m3 TWA United Kingdom, WEL - STEL: (listed as tellurium): 0.3 mg/m3 STEL United States OSHA: 0.1 mg/m3 TWA (listed under Tellurium).
Belgium - TWA: (listed as tellurium): 0.1 mg/m3 VLE France - VME: (listed as tellurium): 0.1 mg/m3 VME Germany: (listed as tellurium): 0.1 mg/m3 VME Malaysia: (listed as tellurium): 0.1 mg/m3 TWA Netherlands: (listed as tellurium): 0.1 mg/m3 MAC Russia: (listed as tellurium): 0.01 mg/m3 TWA Spain: (listed as tellurium): 0.1 mg/m3 VLA-ED CAS# 7440-05-3: Personal Protective Equipment Eyes: Wear appropriate protective eyeglasses or chemical safety goggles as described by OSHAs eye and face protection regulations in 29 CFR 1910.133 or European Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin exposure.
Clothing:
Wear a chemical apron. Wear appropriate clothing to prevent skin exposure.
Respirators:
A respiratory protection program that meets OSHAs 29 CFR 1910.134 and ANSI Z88.2 requirements or European Standard EN 149 must be followed whenever workplace conditions warrant respirator use.
Facilities storing or utilizing this material should be equipped with an eyewash facility and a safety shower. Use adequate general or local explosion-proof ventilation to keep airborne levels to acceptable levels.
Exposure Limits CAS# : United Kingdom, WEL - TWA: (listed as tellurium): 0.1 mg/m3 TWA United Kingdom, WEL - STEL: (listed as tellurium): 0.3 mg/m3 STEL United States OSHA: 0.1 mg/m3 TWA (listed under Tellurium).
Belgium - TWA: (listed as tellurium): 0.1 mg/m3 VLE France - VME: (listed as tellurium): 0.1 mg/m3 VME Germany: (listed as tellurium): 0.1 mg/m3 VME Malaysia: (listed as tellurium): 0.1 mg/m3 TWA Netherlands: (listed as tellurium): 0.1 mg/m3 MAC Russia: (listed as tellurium): 0.01 mg/m3 TWA Spain: (listed as tellurium): 0.1 mg/m3 VLA-ED CAS# 7440-05-3: Personal Protective Equipment Eyes: Wear appropriate protective eyeglasses or chemical safety goggles as described by OSHAs eye and face protection regulations in 29 CFR 1910.133 or European Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin exposure.
Clothing:
Wear a chemical apron. Wear appropriate clothing to prevent skin exposure.
Respirators:
A respiratory protection program that meets OSHAs 29 CFR 1910.134 and ANSI Z88.2 requirements or European Standard EN 149 must be followed whenever workplace conditions warrant respirator use.
Section 9 - PHYSICAL AND CHEMICAL PROPERTIES
Physical State: Solid
Color: black
Odor: Odorless
pH: Not available.
Vapor Pressure: Negligible
Viscosity: Not available.
Boiling Point: Not available.
Freezing/Melting Point: Not available.
Autoignition Temperature: > 100 deg C (> 212.00 deg F)
Flash Point: Not applicable.
Explosion Limits, lower: N/A
Explosion Limits, upper: N/A
Decomposition Temperature: >100 deg C
Solubility in water: insoluble
Specific Gravity/Density: 12.02 g/cm3
Molecular Formula: Pd
Molecular Weight: 106.42
Section 10 - STABILITY AND REACTIVITY
Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Exposure to air, combustible materials, temperatures above 100C.
Incompatibilities with Other Materials:
Strong acids, halogens, oxidizing agents, alcohols, sulfur.
Hazardous Decomposition Products:
Carbon monoxide, irritating and toxic fumes and gases, carbon dioxide.
Hazardous Polymerization: Will not occur.
Stable under normal temperatures and pressures.
Conditions to Avoid:
Exposure to air, combustible materials, temperatures above 100C.
Incompatibilities with Other Materials:
Strong acids, halogens, oxidizing agents, alcohols, sulfur.
Hazardous Decomposition Products:
Carbon monoxide, irritating and toxic fumes and gases, carbon dioxide.
Hazardous Polymerization: Will not occur.
Section 11 - TOXICOLOGICAL INFORMATION
RTECS#:
CAS# unlisted.
CAS# 7440-05-3: RT3480500 RT3593400 LD50/LC50:
Not available.
Not available.
Carcinogenicity:
Activated Carbon - Not listed by ACGIH, IARC, or NTP.
Palladium - Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.
CAS# unlisted.
CAS# 7440-05-3: RT3480500 RT3593400 LD50/LC50:
Not available.
Not available.
Carcinogenicity:
Activated Carbon - Not listed by ACGIH, IARC, or NTP.
Palladium - Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.
Section 12 - ECOLOGICAL INFORMATION
Section 13 - DISPOSAL CONSIDERATIONS
Dispose of in a manner consistent with federal, state, and local regulations.
Section 14 - TRANSPORT INFORMATION
IATA
Shipping Name: FLAMMABLE SOLID, INORGANIC, N.O.S.*
Hazard Class: 4.1
UN Number: 3178
Packing Group: II
IMO
Shipping Name: FLAMMABLE SOLID, INORGANIC, N.O.S.
Hazard Class: 4.1
UN Number: 3178
Packing Group: II
RID/ADR
Shipping Name: FLAMMABLE SOLID, INORGANIC, N.O.S.
Hazard Class: 4.1
UN Number: 3178
Packing group: II
Section 15 - REGULATORY INFORMATION
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: F
Risk Phrases:
R 7 May cause fire.
Safety Phrases:
S 16 Keep away from sources of ignition - No
smoking.
WGK (Water Danger/Protection)
CAS# : No information available.
CAS# 7440-05-3: 0
Canada
CAS# 7440-05-3 is listed on Canadas DSL List.
CAS# is not listed on Canadas Ingredient Disclosure List.
CAS# 7440-05-3 is not listed on Canadas Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# is not listed on the TSCA inventory.
It is for research and development use only.
CAS# 7440-05-3 is listed on the TSCA inventory.
