Name:
Platinum on activated carbon not reduced 5% Pt
Section 1 - Chemical Product
MSDS Name:Platinum on activated carbon not reduced 5% Pt
Synonym:None
Section 2 - COMPOSITION, INFORMATION ON INGREDIENTS
| CAS# | Chemical Name | emsds | EINECS# |
| 7440-06-4 | Platinum | 98.0 | 231-116-1 |
Hazard Symbols: F Risk Phrases: 8 |
Section 3 - HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW
Contact with combustible material may cause fire.
Potential Health Effects
Eye:
May cause eye irritation. May cause lacrimation (tearing), blurred vision, and photophobia. May cause chemical conjunctivitis and corneal damage.
Skin:
May cause skin irritation and possible burns.
Ingestion:
May cause irritation of the digestive tract. May cause nausea, vomiting, abdominal pain, and increased salivation.
Inhalation:
May cause respiratory tract irritation. Vapors may cause dizziness or suffocation. Olfactory fatigue may occur. Can produce delayed pulmonary edema.
Chronic:
No information found.
Section 4 - FIRST AID MEASURES
Eyes: Flush eyes with plenty of water for at least 15 minutes, occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes. Wash clothing before reuse.
Ingestion:
Never give anything by mouth to an unconscious person. Get medical aid. Do NOT induce vomiting. If conscious and alert, rinse mouth and drink 2-4 cupfuls of milk or water.
Inhalation:
Remove from exposure and move to fresh air immediately. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get medical aid.
Notes to Physician:
Antidote: None reported.
Section 5 - FIRE FIGHTING MEASURES
General Information:
As in any fire, wear a self-contained breathing apparatus in pressure-demand, MSHA/NIOSH (approved or equivalent), and full protective gear. During a fire, irritating and highly toxic gases may be generated by thermal decomposition or combustion. Will burn if involved in a fire. Use water spray to keep fire-exposed containers cool. Containers may explode in the heat of a fire. Dust can be an explosion hazard when exposed to heat or flame. Flammable solid. May burn rapidly with flare burning effect. May re-ignite after fire is extinguished.
Extinguishing Media:
Use water spray to cool fire-exposed containers. Water may be ineffective. Do NOT use straight streams of water. For large fires, use water spray, fog or regular foam. Contact professional fire-fighters immediately. For small fires, use dry chemical, carbon dioxide, sand, earth, water spray or regular foam. Cool containers with flooding quantities of water until well after fire is out.
Section 6 - ACCIDENTAL RELEASE MEASURES
General Information: Use proper personal protective equipment as indicated in Section 8.
Spills/Leaks:
Scoop up with a nonsparking tool, then place into a suitable container for disposal. Avoid generating dusty conditions. Remove all sources of ignition. Provide ventilation. A vapor suppressing foam may be used to reduce vapors.
Section 7 - HANDLING and STORAGE
Handling:
Wash thoroughly after handling. Remove contaminated clothing and wash before reuse. Use only in a well-ventilated area. Minimize dust generation and accumulation. Ground and bond containers when transferring material. Use spark-proof tools and explosion proof equipment. Avoid contact with eyes, skin, and clothing. Empty containers retain product residue, (liquid and/or vapor), and can be dangerous. Keep away from heat, sparks and flame. Avoid ingestion and inhalation. Do not pressurize, cut, weld, braze, solder, drill, grind, or expose empty containers to heat, sparks or open flames.
Storage:
Keep away from heat, sparks, and flame. Keep container closed when not in use. Store in a tightly closed container. Store in a cool, dry, well-ventilated area away from incompatible substances.
Flammables-area.
Section 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION
Engineering Controls:
Facilities storing or utilizing this material should be equipped with an eyewash facility and a safety shower. Use adequate general or local explosion-proof ventilation to keep airborne levels to acceptable levels.
Exposure Limits CAS# 7440-06-4: United Kingdom, WEL - TWA: 5 mg/m3 TWA United Kingdom, WEL - STEL: 15 mg/m3 STEL United States OSHA: 0.002 mg/m3 TWA Belgium - TWA: 1 mg/m3 VLE France - VME: 1 mg/m3 VME Germany: 1 mg/m3 TWA (inhalable fraction) Malaysia: 1 mg/m3 TWA Netherlands: 1 mg/m3 MAC Spain: 1 mg/m3 VLA-ED Personal Protective Equipment Eyes: Wear appropriate protective eyeglasses or chemical safety goggles as described by OSHAs eye and face protection regulations in 29 CFR 1910.133 or European Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin exposure.
Clothing:
Wear appropriate protective clothing to prevent skin exposure.
Respirators:
A respiratory protection program that meets OSHAs 29 CFR 1910.134 and ANSI Z88.2 requirements or European Standard EN 149 must be followed whenever workplace conditions warrant respirator use.
Section 9 - PHYSICAL AND CHEMICAL PROPERTIES
Physical State: Solid
Color: black
Odor: Not available.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: 3827 deg C @ 7600.00mm Hg
Freezing/Melting Point: 1769 - 1773 deg C
Autoignition Temperature: Not available.
Flash Point: Not available.
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water: insoluble
Specific Gravity/Density: 21.4500g/cm3
Molecular Formula: Pt
Molecular Weight: 195.08
Section 10 - STABILITY AND REACTIVITY
Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, ignition sources, dust generation, excess heat, strong oxidants.
Incompatibilities with Other Materials:
Strong oxidizing agents, hydrazine, phosphorus, hydrogen peroxides, acetone, arsenic, dioxygen difluoride, white phosphorus, nitrosyl chloride, ethanol, selenium, tellurium.
Hazardous Decomposition Products:
Carbon monoxide, irritating and toxic fumes and gases, carbon dioxide.
Hazardous Polymerization: Has not been reported
Section 11 - TOXICOLOGICAL INFORMATION
RTECS#:
CAS# 7440-06-4: TP2160000 LD50/LC50:
Not available.
Carcinogenicity:
Platinum - Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.
Section 12 - ECOLOGICAL INFORMATION
Section 13 - DISPOSAL CONSIDERATIONS
Dispose of in a manner consistent with federal, state, and local regulations.
Section 14 - TRANSPORT INFORMATION
IATA
Shipping Name: FLAMMABLE SOLID, INORGANIC, N.O.S.*
Hazard Class: 4.1
UN Number: 3178
Packing Group: II
IMO
Shipping Name: FLAMMABLE SOLID, INORGANIC, N.O.S.
Hazard Class: 4.1
UN Number: 3178
Packing Group: II
RID/ADR
Shipping Name: FLAMMABLE SOLID, INORGANIC, N.O.S.
Hazard Class: 4.1
UN Number: 3178
Packing group: II
Section 15 - REGULATORY INFORMATION
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: F
Risk Phrases:
R 8 Contact with combustible material may cause
fire.
Safety Phrases:
S 9 Keep container in a well-ventilated place.
S 16 Keep away from sources of ignition - No
smoking.
S 28A After contact with skin, wash immediately with
plenty of water.
S 33 Take precautionary measures against static
discharges.
S 37 Wear suitable gloves.
S 45 In case of accident or if you feel unwell, seek
medical advice immediately (show the label where
possible).
WGK (Water Danger/Protection)
CAS# 7440-06-4: 0
Canada
CAS# 7440-06-4 is listed on Canadas DSL List.
CAS# 7440-06-4 is listed on Canadas Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 7440-06-4 is listed on the TSCA inventory.