Section 1 - Chemical Product
MSDS Name:Protran 2 Solution
Synonym:None
Section 2 - COMPOSITION, INFORMATION ON INGREDIENTS
| CAS# | Chemical Name | emsds | EINECS# |
| 109-99-9 | Tetrahydrofuran | 85 | 203-726-8 |
Hazard Symbols: F+ Risk Phrases: 11 19 36/37 |
Section 3 - HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW
Highly flammable. May form explosive peroxides. Irritating to eyes and respiratory system.
Potential Health Effects
Eye:
Causes eye irritation.
Skin:
May cause skin irritation.
Ingestion:
May cause irritation of the digestive tract. May be harmful if swallowed.
Inhalation:
Causes respiratory tract irritation. Causes irritation of mucous membrane. Vapors may cause dizziness or suffocation.
Chronic:
No information found.
Section 4 - FIRST AID MEASURES
Eyes: Immediately flush eyes with plenty of water for at least 15 minutes, occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid. Immediately flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes.
Wash clothing before reuse.
Ingestion:
Do not induce vomiting. If victim is conscious and alert, give 2-4 cupfuls of milk or water. Never give anything by mouth to an unconscious person. Get medical aid immediately. Wash mouth out with water.
Inhalation:
Get medical aid immediately. Remove from exposure and move to fresh air immediately. If not breathing, give artificial respiration. If breathing is difficult, give oxygen.
Notes to Physician:
Antidote: None reported.
Section 5 - FIRE FIGHTING MEASURES
General Information:
As in any fire, wear a self-contained breathing apparatus in pressure-demand, MSHA/NIOSH (approved or equivalent), and full protective gear. Vapors may form an explosive mixture with air.
Vapors can travel to a source of ignition and flash back. Use water spray to keep fire-exposed containers cool. Extremely flammable liquid and vapor. Containers may explode in the heat of a fire. Will be easily ignited by heat, sparks or flame.
Extinguishing Media:
For small fires, use dry chemical, carbon dioxide, water spray or alcohol-resistant foam. For large fires, use water spray, fog, or alcohol-resistant foam. Use water spray to cool fire-exposed containers. Water may be ineffective. Do NOT use straight streams of water. In case of fire, use carbon dioxide, dry chemical powder or appropriate foam.
Section 6 - ACCIDENTAL RELEASE MEASURES
General Information: Use proper personal protective equipment as indicated in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth), then place in suitable container. Avoid runoff into storm sewers and ditches which lead to waterways. Clean up spills immediately, observing precautions in the Protective Equipment section. Remove all sources of ignition. Use a spark-proof tool. Provide ventilation. A vapor suppressing foam may be used to reduce vapors.
Section 7 - HANDLING and STORAGE
Handling:
Wash thoroughly after handling. Use only in a well-ventilated area.
Ground and bond containers when transferring material. Avoid contact with eyes, skin, and clothing. Empty containers retain product residue, (liquid and/or vapor), and can be dangerous. Keep container tightly closed. Keep away from heat, sparks and flame. Avoid ingestion and inhalation. If peroxide formation is suspected, do not open or move container. Do not pressurize, cut, weld, braze, solder, drill, grind, or expose empty containers to heat, sparks or open flames.
Storage:
Keep away from heat, sparks, and flame. Keep away from sources of ignition. Store in a cool, dry, well-ventilated area away from incompatible substances. Flammables-area. Keep containers tightly closed.
Section 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION
Engineering Controls:
Facilities storing or utilizing this material should be equipped with an eyewash facility and a safety shower. Use adequate general or local explosion-proof ventilation to keep airborne levels to acceptable levels.
Exposure Limits CAS# 109-99-9: United Kingdom, WEL - TWA: 50 ppm TWA; 150 mg/m3 TWA United Kingdom, WEL - STEL: 100 ppm STEL; 300 mg/m3 STEL United States OSHA: 200 ppm TWA; 590 mg/m3 TWA Belgium - TWA: 200 ppm VLE; 599 mg/m3 VLE Belgium - STEL: 100 ppm VLE; 300 mg/m3 VLE France - VME: 200 ppm VME; 590 mg/m3 VME Germany: 50 ppm TWA; 150 mg/m3 TWA Germany: Skin absorber Japan: 200 ppm OEL; 590 mg/m3 OEL Malaysia: 200 ppm TWA; 590 mg/m3 TWA Netherlands: 100 ppm MAC; 300 mg/m3 MAC Russia: 100 mg/m3 TWA Spain: 50 ppm VLA-ED; 150 mg/m3 VLA-ED Spain: 100 ppm VLA-EC; 300 mg/m3 VLA-EC Personal Protective Equipment Eyes: Wear appropriate protective eyeglasses or chemical safety goggles as described by OSHAs eye and face protection regulations in 29 CFR 1910.133 or European Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin exposure.
Clothing:
Wear appropriate protective clothing to prevent skin exposure.
Respirators:
Follow the OSHA respirator regulations found in 29 CFR 1910.134 or European Standard EN 149. Use a NIOSH/MSHA or European Standard EN 149 approved respirator if exposure limits are exceeded or if irritation or other symptoms are experienced.
Section 9 - PHYSICAL AND CHEMICAL PROPERTIES
Physical State: Liquid
Color: clear
Odor: Not available.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: Not available.
Freezing/Melting Point: Not available.
Autoignition Temperature: Not available.
Flash Point: -14 deg C ( 6.80 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water: Miscible.
Specific Gravity/Density:
Molecular Formula:
Molecular Weight:
Section 10 - STABILITY AND REACTIVITY
Chemical Stability:
Prolonged exposure to air and sunlight may form unstable peroxides.
Explosive peroxides may form on concentration. Peroxides can be detonated by friction, impact, or heating. Peroxide formation may occur in containers that have been opened and remain in storage.
Normally stable; however, on long term storage, materials containing similar functional groups form peroxides of unknown stability.
Conditions to Avoid:
Incompatible materials, ignition sources, excess heat.
Incompatibilities with Other Materials:
Sodium hydroxide, alkalies, potassium hydroxide, bromine, lithium tetrahydroaluminate, metallic halides, borane, 2-aminophenol + potassium dioxide, calcium hydride + heat.
Hazardous Decomposition Products:
Acrid smoke and fumes.
Hazardous Polymerization: Has not been reported
Section 11 - TOXICOLOGICAL INFORMATION
RTECS#:
CAS# 109-99-9: LU5950000 LD50/LC50:
CAS# 109-99-9: Inhalation, rat: LC50 = 21000 ppm/3H; Oral, rat: LD50 = 1650 mg/kg.
Carcinogenicity:
Tetrahydrofuran - ACGIH: A3 - Confirmed animal carcinogen with unknown relevance to Other:
See actual entry in RTECS for complete information.
Section 12 - ECOLOGICAL INFORMATION
Ecotoxicity:
Cas# 109-00-0: LC50(96Hr.) Fathead Minnow = 2160 mg/L
Section 13 - DISPOSAL CONSIDERATIONS
Products which are considered hazardous for supply are classified as Special Waste and the disposal of such chemicals is covered by regulations which may vary according to location. Contact a specialist disposal company or the local waste regulator for advice. Empty containers must be decontaminated before returning for recycling.
Section 14 - TRANSPORT INFORMATION
IATA
No information available.
IMO
No information available.
RID/ADR
No information available.
USA RQ: CAS# 109-99-9: 1000 lb final RQ; 454 kg final RQ
Section 15 - REGULATORY INFORMATION
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: F+
Risk Phrases:
R 11 Highly flammable.
R 19 May form explosive peroxides.
R 36/37 Irritating to eyes and respiratory system.
Safety Phrases:
S 16 Keep away from sources of ignition - No
smoking.
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
S 29 Do not empty into drains.
S 33 Take precautionary measures against static
discharges.
WGK (Water Danger/Protection)
CAS# 109-99-9: 1
Canada
CAS# 109-99-9 is listed on Canadas DSL List.
CAS# 109-99-9 is listed on Canadas Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 109-99-9 is listed on the TSCA inventory.